Introduction to the processing method of brush tufting machine
It is to process the product continuously, without stopping in the middle, unless the "stop" button is pressed, and only when more than 2 fixtures are placed, the cyclic processing of the product can be completed. Fully automatic processing can improve production efficiency. When the product on one fixture is processed and the product on two fixtures is processed, the product on one fixture can be exchanged, and when the product on two fixtures is processed, the product on one fixture can be exchanged. products, complete the reciprocating processing. If only one fixture is placed, only semi-automatic processing can be used.
In the standby state, press the number key "1" on the panel to enter the fully automatic working mode. When maintenance occurs, the entire mechanical action is stopped. After repairing, move the machine head to the high position and use the "single step" key. Find the vacant position, and then press the "start" key to process, otherwise, in the original processed hole position, press the start key to process, there will be a heavy hole phenomenon, which may damage the needle. Special attention should be paid to the operation, and it should also be paid attention to during semi-automatic processing.
Press the "start" button once to process once. After processing the product, the machine head stops at a high position and runs to the starting point. To exchange products, press the "start" key again, run to a hole position, and process it again. It can also be processed from the beginning of N holes to a hole. N can be set. After entering the hole number through the keyboard, press the upper hole, The hole key is rotated to the hole, to ensure that the hole has not been processed, and then press the "start" key to process, otherwise the needle will be damaged. When maintenance occurs, the treatment method is the same as that of fully automatic processing.
