Reasons for the quality of brush tufting machine products in brush making equipment
The brush tufting machine in the brush making equipment is a very common one, and there are many products that can be planted, including toothbrushes, brushes, shoe brushes, hair hubs, etc., which can be produced by the brush tufting machine. Brush products can be applied in various fields and industries. Today's editor is discussing with you the factor analysis of the quality of the products produced by the brush tufting machine.
Reasons why the quality of brush tufting machine products in brush making equipment is not good enough:
First: Simple bending of copper wire
1. The copper cutting part of the brush tufting head is worn and replaced. 2. The copper cutting knife is worn and replaced. 3. If the hair planting head and the copper cutting knife are not adjusted properly, adjust them from scratch. 4. If there is a foreign body on the contact surface between the hair-planting head and the hair-planting head, remove it and remove it. 5. If the height of the copper cutting knife is not adjusted properly, adjust it from the beginning; if the copper wire is adjusted too long, shorten the copper wire. 6. The copper wire is of poor quality, such as bent, too wide or too thick, replace the new copper wire.
Second: The copper wire size of the brush tufting machine has different lengths after the copper wire is cut. 1. The copper wire clip is worn, and it should be reground or replaced. 2. The copper wire backstop is worn, and the copper wire backstop is used or replaced.
Third: the point of view of the copper wire entering the brush handle is wrong when the hair is planted, so that the copper wire cannot be stuck on the bristles or the copper wire is simply dropped. 1. The size of copper wire, refer to the size of copper wire. 2. The copper wire adjustment is too short. 3. When planting hair, the distance between the hair planting head and the brush handle is too large, adjust the distance between the front and rear. 4. The front end of the hair-planting needle is worn, smoothed or replaced. 5. The front end of the hair-planting head is worn out, and the hair-planting head is replaced.
