Operating Instructions for Hair Planting Machines in Brush Making Equipment
The hair planting machine in the brush making equipment production equipment is very high in the CNC factory equipment, and it can not only plant hair but also silk, etc., and the material supports more than 30 kinds, so its market share is very high, today Xiaobian will give you Introduce the operating instructions of the hair planting machine.
The operation instructions of the hair planting machine in the brush making equipment production equipment are as follows:
1. Connect the power supply correctly according to the rotation direction of the motor, and be sure to connect the ground wire safely and place it stably.
2. After the power is turned on, press the "green" button, the suction fan starts (that is, the dust exhaust fan works), the two inverters are powered at the same time, and the standby state is displayed, and the panel displays "0" at the same time. Press the "red" button. stop working.
3. There are two positioning fixtures on the feeding table, which are positioned by the tip of the hair, that is, combing with a handle. This combing method can press tightly and the brush is not easy to be damaged. Another method is to use the iron shell to position the brush. This combing method puts the brush quickly, but the thickness of the brush head is not uniform, which is easy to damage the brush head, and at the same time, the pressure will also damage the brush head. brush head.
4. According to the thickness of the brush, adjust the lifting screws at both ends of the machine, so that the brush is pressed tightly and smoothly enters the engine room with the rubber chain, and the compression spring is in a stressed state (that is, the lower end of the M12 double nut and the groove iron plane are raised by 3mm ~5mm clearance is sufficient).
5. If there is too much waste hair in the rubber chain and sprocket tooth groove, it should be cleaned in time, otherwise the chain slips, the pressure is not tight, and the dislocation is easy to cause damage to the brush and damage to the rubber. At the same time, add some lubricating oil to the chain and sprocket. The gearbox oil is changed every 500 hours of operation. Change the oil within 1 week for the first time.
